cisco switch helpful commands
by
zemerdon »
Sun Oct 05, 2025 4:17 pm
backup config tftp
copy running-config tftp:
cisco show ip
show ip int
console connect
sudo screen /dev/ttyUSB0 9600
remove stack members...
0 Replies
13633 Views
Last post by zemerdon
Sun Oct 05, 2025 4:17 pm
helpful linux commands
Replies: 1
by
zemerdon »
Sat Jun 21, 2025 5:45 am
» in
Linux
netstat dont list unix sockets
netstat -na --inet --inet6
find processes using mount point
sudo fuser -mv /mount/point
watch with pipe...
1 Replies
24650 Views
Last post by zemerdon
Tue Dec 09, 2025 4:15 pm
Cisco 3650 stack configuration
by
zemerdon »
Sat Feb 14, 2026 1:16 pm
show switch: Displays stack membership and status.
show switch detail: Provides detailed stack information.
switch X renumber Y: Changes a switch...
0 Replies
1185 Views
Last post by zemerdon
Sat Feb 14, 2026 1:16 pm
0 Replies
773 Views
Last post by zemerdon
Thu Jan 15, 2026 1:04 pm
0 Replies
764 Views
Last post by zemerdon
Fri Jan 02, 2026 6:23 pm
Cipher Mismatch/No shared cipher
by
zemerdon »
Fri Jan 02, 2026 5:38 pm
conf t
#no crypto pki trustpoint TP-Self-Signed-xxxxxxxxxx
no ip http server
no ip http secure-server
ip http server
ip http secure-server
ip http...
0 Replies
788 Views
Last post by zemerdon
Fri Jan 02, 2026 5:38 pm
cisco 3650 recovery
by
zemerdon »
Fri Jan 02, 2026 5:01 pm
non-booting
flash_init
emergency-install usbflash0:/cat3k_caa-universalk9.16.12.14.SPA.bin
clean install firmware:
format flash:
copy...
0 Replies
738 Views
Last post by zemerdon
Fri Jan 02, 2026 5:01 pm
0 Replies
5166 Views
Last post by zemerdon
Sun Oct 05, 2025 3:08 pm
cisco 2960 show unit temp
by
zemerdon »
Sat Feb 01, 2025 5:11 pm
2960s_roof_end>enable
Password:
2960s_roof_end#show env all
FAN is OK
SYSTEM TEMPERATURE is OK
System Temperature Value: 37 Degree Celsius
System...
0 Replies
142073 Views
Last post by zemerdon
Sat Feb 01, 2025 5:11 pm
Cisco 2960 hard reset
by
zemerdon »
Sat Dec 14, 2024 11:59 am
Find the below steps to recovery password for Cisco 2960.
Step 1:
Power off the switch first, then press and hold the mode button while you power...
0 Replies
33370 Views
Last post by zemerdon
Sat Dec 14, 2024 11:59 am
0 Replies
34297 Views
Last post by zemerdon
Sat Dec 14, 2024 11:49 am
0 Replies
30643 Views
Last post by zemerdon
Sat Dec 14, 2024 11:35 am
reset switch
by
zemerdon »
Sat Dec 14, 2024 11:24 am
Reset Switch Configuration
To reset the switch to factory default, issue thee rase startup-config or write erase command. This command does not clear...
0 Replies
32041 Views
Last post by zemerdon
Sat Dec 14, 2024 11:24 am
Cisco upgrade via CLI TFTP
by
zemerdon »
Mon Dec 09, 2024 6:35 pm
3650:
software install file t new force
2960:
archive download-sw /overwrite /reload t
setup TFTP server
Upgrading a Switch by Using the...
0 Replies
31878 Views
Last post by zemerdon
Mon Dec 09, 2024 6:35 pm
port flapping
by
zemerdon »
Tue Jan 30, 2024 10:17 am
A MAC Flap is caused when a switch receives packets from two different interfaces with the same source MAC address. If you are getting the behaviour...
0 Replies
32294 Views
Last post by zemerdon
Tue Jan 30, 2024 10:17 am
0 Replies
27927 Views
Last post by zemerdon
Mon Jan 08, 2024 12:03 pm
cisco syslog server setup
by
zemerdon »
Mon Jan 08, 2024 12:15 am
On the Cisco Catalyst 2960 switch, open the Cisco command-line interface and begin a session.
Verify that you are in privileged EXEC mode on the...
0 Replies
27738 Views
Last post by zemerdon
Mon Jan 08, 2024 12:15 am
0 Replies
28212 Views
Last post by zemerdon
Sun Jan 07, 2024 11:48 pm
0 Replies
27813 Views
Last post by zemerdon
Sun Jan 07, 2024 11:47 pm
Cisco 2960S enable SSH
Replies: 1
by
zemerdon »
Sun Jan 07, 2024 10:00 pm
1- Give the switch a hostname (hostname xxxxxx)
2- Give the switch a domain name (ip domain-name xxx.com)
3- Create a username and password...
1 Replies
35295 Views
Last post by zemerdon
Sun Jan 07, 2024 11:31 pm
show logs
by
zemerdon »
Sun Jan 07, 2024 10:22 pm
Show running-config
sh int
show log
0 Replies
28936 Views
Last post by zemerdon
Sun Jan 07, 2024 10:22 pm
0 Replies
28505 Views
Last post by zemerdon
Sun Jan 07, 2024 10:20 pm
Cisco 2960S show hostname
by
zemerdon »
Sun Jan 07, 2024 10:12 pm
Switch#show running-config
Building configuration...
Current configuration : 3235 bytes
!
! Last configuration change at 01:01:04 UTC Mon Jan 2 2006
0 Replies
27593 Views
Last post by zemerdon
Sun Jan 07, 2024 10:12 pm
0 Replies
28461 Views
Last post by zemerdon
Tue Dec 26, 2023 9:31 am
Forum permissions
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum